Amana 12828148 Guide D'utilisation Et D'entretien page 5

Installation
Door and Drawer Removal
Some installations require door/drawer removal to
transport the refrigerator to its final location.
Materials Needed:
• Phillips screwdriver
• 5 ⁄ " hex head driver
1 6
• ⁄ " hex head driver
3
8
WARNING
To avoid electrical shock which can cause
severe personal injury or death, observe the
following:
• Disconnect power to refrigerator before removing
doors or drawer. Connect power only after
replacing doors or drawer.
CAUTION
To avoid damage to walls and flooring, protect vinyl
or other flooring with cardboard, rugs or other
protective material.
1. Unplug power cord from power source.
2. Remove toe grille (see page 3).
3. Remove top hinge cover from
refrigerator door by removing Phillips
screw and retain screw and cover for
later use.
4. Unscrew 5 " hex head screws from
⁄
16
top hinge to remove hinge and retain
all screws for later use.
5. Lift right side refrigerator door from
center hinge pin. Remove door
closure from center hinge pin on the
right side and retain for later use.
6. Disconnect wire harness on top
of left side refrigerator door top
hinge.
• Release two-pin connector by
pressing junction point with a
flat blade screwdriver or
fingernail.
• Green ground wire remains
attached to the hinge.
7. Unscrew 5 ⁄ " hex head screws from
1 6
top hinge to remove hinge and
retain for later use.
• Lift left side refrigerator
door, along with top hinge,
from center hinge pin.
• Remove center hinge pin
with a
and retain hinge pin for later
use.
8. Remove Phillips screws to remove right and left
hinges and retain all screws for later use.
9. Remove both stabilizing brackets with
driver and retain screws for later use.
Pullout Freezer Drawer
To prevent accidental child entrapment or
suffocation risk, do not remove the divider in the
top freezer basket.
To avoid electrical shock, which can cause severe
personal injury or death, disconnect power to
refrigerator before removing doors. After replacing
doors, connect power.
To avoid possible injury, product, or property
damage, you will need two people to perform the
following instructions.
To Remove:
1. Pull drawer open to full extension.
2. Pull upper basket out to full extension and lift out
right
to remove.
side
door
3. Lift lower basket straight up and out to remove.
closure
4. On each side rail is a basket cradle
with two snap attachments. To
release each cradle, unlatch the
snaps by pushing them inward,
away from the side rail system. Lift
the cradles off of the rails.
5. Lift top of drawer front to unhook
supports from rail system. Lift door
front out to remove.
5 ⁄ " hex head driver
1 6
DANGER
WARNING
CAUTION
" hex head
3 ⁄
8
4