Télécharger Imprimer la page

ShelterLogic ShelterCoat 10'W x 8'H Round Manuel D'installation page 8

Masquer les pouces Voir aussi pour ShelterCoat 10'W x 8'H Round:

Publicité

Les langues disponibles

Les langues disponibles

10. INSTALLING COVER AND COVER RAILS
A. Lay the cover on the ground next to the frame with inside of the cover (the side with the pipe pockets) facing
down and the webbing on the front and rear of the corner of the building.
B. Pull cover over the frame, making sure to center cover on frame. There should be an equal amount of
overhang at all four corners.
C. Insert the "S"- Hook on ratchet into hole on the leg bend. Insert the webbing into the spindle of the ratchet
and pull tight. Wind the ratchet so that the webbing overlaps itself.
D. Slide cover rails (#10110) through fabric pockets at each leg and attach with clamps to each leg.
Repeat this on other side. Push down on cover rails to tighten cover, before tightening bolts completely.
E. Check and tighten Ratchets and Cover Rails monthly to ensure the cover is tight.
NOTE: The ShelterLogic
be oriented as shown below.
INCORRECT
Webbing and Ratchets Securing Cover
logo should
®
CORRECT
REAR
End Rib Cross Rail Clamps
10112
10115
10110
01010
Page 8
Fig.10
# 10110
COVER RAILS
Middle Rib Cross Rail Clamps
10110
10111
01010
05_GP-BA-XXXXXXA-010XXX08_E1
FRONT
10115
10110

Publicité

loading