ShelterLogic ShelterCoat 10'W x 8'H Round Manuel D'installation page 4

NOTE: FRAME EXTENSION KIT
10'x8'x8' is the BASE frame dimension. Your model may have more middle ribs than shown in the illustration on
page 3. You will receive one extra rib for every extra 4 ft. of building length that you purchase. The basic frame
assembly will remain the same. The cover will be the correct size for the length of the building you purchased.
Fig.1
1. PLOTTING THE FRAME:
A B
Before building your shelter, you should choose a flat area on
your property and plot your shelter.
10'
A. Stake out the area for the shelter in the desired spot. The width of
WIDTH
the area should be at least equal to the width of the shelter and the
length should be equal to the length of the shelter Fig. 1.
B. Measure diagonally from corner to corner (A & B). These
measurements should be the same. If they are not equal the stakes
need to be adjusted until the width, length and inside measurements
are correct.
BUILDING
LENGTH
800468 800469
10210 - 3" Bolt
Fig.2
2. ASSEMBLE END RIBS
Assemble end ribs as shown in Fig. 2. Securely
fasten all of the joints with the hardware indicated.
10226 10226
10114 - 2" Bolt
NOTE: HAND-TIGHTEN the 3" Bolt (# 10210) at the top.
800468 800469
Fig.3
10210 - 3" Bolt
3. ASSEMBLE MIDDLE RIBS
Assemble middle ribs as shown in Fig. 3. Securely
10273 10273
fasten all of the joints with the hardware indicated.
10114 - 2" Bolt
10270 10270
Page 4 05_GP-BA-XXXXXXA-010XXX08_E1