Connection Instructions - Nexgrill FORTRESS Manuel D'utilisation

GAS HOOK-UP
Only the pressure regulator and hose assembly supplied with the grill should be used. Any replacement pressure regulator
and hose assembly should comply with EN 16129:2013 and the national regulation. The flexible hose used, with a length
not exceeding 1.50 meters, should comply with EN 16436-1:2014. This grill is configured for liquefied petroleum gas. Do not
use a natural gas supply.
Total gas consumption (per hour) with all burners set on "HIGH":
EACH BURNER
TOTAL
Only use cylinders with a minimum capacity of 5 kg and a maximum capacity of 15 kg. A tank of
approximately 318 mm (12.5 in) in diameter by 580 mm (22.8 in) in height shall be the maximum
size LPG cylinder which can be used.
A dented or rusty LPG cylinder may be hazardous and should be checked by your supplier. Never
use a cylinder with a damaged valve. The LPG supply cylinder to be used must be constructed and
marked in accordance with the specifications for LPG cylinders that adhere to national regulations
for the country of use. The gas cylinder must have a shut-off valve terminating at the valve outlet.
Storage of an outdoor cooking gas appliance indoors is permissible only if the cylinder is
disconnected and removed from the outdoor cooking gas appliance. The cylinder system must be
arranged for vapour withdrawal. The cylinder must include a collar to protect the cylinder valve.
Manifold pressure: (operating) 27.9 cm (11 in) water column, (non-operating) 28.4 cm (11.2 in) water
column.
The LPG cylinder must be fitted with an overfill protection device (OPD). Remove the plastic valve
cover from the LPG cylinder. Make sure the grill gas hoses do not contact the grease pan or grill
firebox when the LPG cylinder is placed into the cart.
WARNING:
NEVER ATTEMPT TO USE DAMAGED OR OBSTRUCTED EQUIPMENT. SEE YOUR LOCAL LIQUEFIED
PETROLEUM GAS DEALER FOR REPAIR.
REPLACING THE LIQUEFIED PETROLEUM GAS CYLINDER
Turn the grill burner valves "OFF" () and make sure the grill is cool.
Turn the LPG cylinder valve to the CLOSED position by turning clockwise until it stops.
Detach the regulator assembly from the cylinder valve by first turning regulator lever clockwise to the OFF position, and then
press the push button on the lower part of the regulator. Lift the regulator away from the cylinder valve.
Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust cap on the cylinder valve
outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage of gas.
6,000 BTU/HR.
12,000 BTU/HR.
LIQUEFIED PETROLEUM GAS CYLINDER REQUIREMENTS
CONNECTING THE LIQUEFIED PETROLEUM GAS CYLINDER

CONNECTION INSTRUCTIONS

318 mm (maximum)
LPG CYLINDER
8