Clatronic BS 1235 Mode D'emploi & Garantie page 41

5....-05-BS 1235 17.10.2003 11:41 Uhr Seite 41
Telescopic Suction Tube (13):
GB
As the length of the suction tube can be adjusted it can be adapted to your own
personal height. Unlock the coupling by pressing the button (14) downwards. Then
move the telescopic suction tube to the desired height. To fix the suction tube in
position, pull it until it is heard to lock in place.
Cable winding device:
Pull out the cable (1) up to the maximum length indicated with the yellow mark.
Never pull the cable out up to the red mark as the cable winding can be damaged.
Said damages are not covered by the warranty.
Winding:
Press the cable (5) winding button and guide the cable. Hold the cable to avoid wrap-
ping.
Air Slide:
Open the air slide on the hose handle in order to regulate the airflow or to clear any
particles sticking to the nozzle.
Dust bag replacement display (7):
Hold the hose up into air. If the dust bag change display lights up, the bag is full.
Please change it.
Changing the dust bag:
Pull the plug out of the socket. Press the button (9) to open the lid of the dust bag
compartment (until its locks in place). Remove the dust bag holder and pull the dust
bag out of the holder. Insert a new dust bag. Reinsert the dust bag holder. Close
the cover so that it snaps into place.
Filter: Your appliance has two filters.
Motor protection filter (inlet filter):
The inlet filter is located in the dust bag compartment. Press the button (9) to open the
lid of the dust bag compartment. The filter is located vertically in the rear section of the
dust housing. Remove the filter by pulling upwards. Clean the engine protection filter
after 10 dust bag changes. If necessary, the filter can also be washed in warm water
without any additives. Place it back into place only once it is completely dry!
Outlet filter:
The appliance is also equipped with an outlet filter. It is located on the rear part of
your appliance behind a ventilation grid. Open the ventilation grille by pressing the
button above it.Then pull the grille out towards the front. Remove the filter and clean
as described above. Fit the filter back into place and close the ventilation grid by fol-
lowing the steps above in the opposite order.
41