Clatronic BS 1235 Mode D'emploi & Garantie page 40

5....-05-BS 1235
12 Parking assistance
GB
13 Telescopic suction tube
14 Telescopic suction tube button
15 Floor nozzle
1. Insert the connection head of the suction hose (11) into the hose connection
(10) until its locks in place.
2. In order to release the hose again, press the two buttons on the side of the suc-
tion hose at the same time.
3. Keep the buttons pressed and then pull the hose out.
1. Attach the floor nozzle (15) or the accessory.
2. Unwind the length of cable (1) you require.
3. Insert the mains plug into a correctly installed safety socket (230 V, 50 Hz) and
then switch the machine on using the on/off switch (2).
4. Set the vacuum power with the vacuum power regulator (3).
5. Vacuum at a steady speed. There is no need to exert pressure.
6. Attention: pay attention to the range that can be covered with the cable length.
Accessory Compartment (6):
The integrated accessories (crevice nozzle, upholstery nozzle) can be found by pul-
ling the lid of the accessory compartment.
Nozzle accessories:
Crevice nozzle:
Upholstery nozzle:
Floor nozzle (15):
Releasing the accessories:
Pull them apart while turning slightly.
Vacuum power regulator (3):
Low vacuum power:
Medium vacuum power:
High vacuum power:
40
17.10.2003 11:41 Uhr
16 Mains control lamp
Accessories:
Crevice nozzle, Upholstery nozzle
Start-up
Using the Appliance
For vacuuming in corners and crevices.
For cleaning upholstery, curtains etc.
For cleaning carpets or smooth surfaces.
Smooth floors: Press the lever with the brush symbol
down with your foot. The brushes are
now visible.
Carpets: Press down the opposite lever.
For curtains and delicate fabrics
For long-pile velour carpets and textile flooring
For sturdy rugs and floors
Seite 40