ZANKER KDI10001XB Notice D'utilisation page 16

Adjusting the water softener
German
degrees
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
How to adjust the level of the water softener
1. Turn the knob until the programme marker is
aligned with
appliance is in setting mode.
2. Press and hold the start button until the start indi-
cator, the on/off indicator and
• The intermittent flashing of
current set level,, e.g. 5 flashes + pause + 5
flashes = level 5.
3. Press the start button again and again to change
the setting. Each time you press the start button
the level number increases.
4. To confirm the setting and deactivate the appli-
ance, turn the knob until the programme marker is
aligned with the on/off indicator.
Filling the salt container
Caution! Water and salt can come out from the
salt container when you fill it. Risk of corrosion.
To prevent it, after you fill the salt container, start a
programme.
16
Water hardness
French mmol/l
degrees
(°fH)
84 - 90 8.4. - 9.0
76 - 83 7.6 - 8.3
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7 < 0.7
. Make sure that the
start to flash.
refers to the
Clarke
degrees
58 - 63
53 - 57
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
1
3
Put 1 litre of water in the salt container (only for the
first time).
Water softener
adjustment
Level
10
9
8
7
6
1)
5
4
3
2
2)
1
2
4