Spray Tip Maintenance; Transportation And Storage; Move The Machine; Store The Machine - GreenWorks GPW 1803 Manuel De L'utilisateur

EN
5.1

SPRAY TIP MAINTENANCE

If there is too much pump pressure, the spray tip can become
clogged, you can feel a pulsing sensation while you pull the
spray gun trigger.
5.1.1 REMOVE THE SPRAY TIP
1. Pull back the quick-connect collar on the spray wand (2).
2. Remove the spray tip (11) from the spray wand (2).
5.1.2 CLEAN THE SPRAY TIP
1. Use a straight paper clip or cleaning tool (21) to clean the
spray tip (11).
2. Flush and clean the unwanted materials out of the spray
tip (11) with the garden hose (20).
3. Install the clean spray tip (11) to the spray wand (2).
6 TRANSPORTATION AND
STORAGE
Disconnect the power cord and watter supply hose before

transportation and storage.

6.1

MOVE THE MACHINE

• Point the spray wand in a safe direction.
• Only hold the machine with the handgrip.
6.2

STORE THE MACHINE

Make sure that the spray gun, the high pressure hose and the
pump are dry.
Make sure the machine is out of the reach of children.
Use a recommended pump protector to prevent cold
weather damage during storage in winter.
• Disconnect the garden hose from machine.
• Wind the power cord and the high pressure hose.
• Clean housing and the plastic components with a moist
and soft cloth.
①
②
③
WARNING
WARNING
WARNING
NOTE
English
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• If needed, call the customer service phone number
(enter number here) for servicing instructions.
• Store the machine in a dry, isolated and frost-free area.
7

TROUBLESHOOTING

PROBLEM
The motor does
not start.
The machine does
not reach high
pressure.
12
POSSIBLE SOLUTION
CAUSE
The power button Set the power
is in the "OFF" switch to the
(O) position. "ON" ( | ) posi-
tion.
The power cord is Connect the power
not plugged in. cord to the power
supply.
Electrical outlet Try another elec-
does not supply trical outlet.
sufficient power.
The circuit breaker Let it cool, and
is tripped. start the machine
again.
The power switch Pull the spray gun
is on, but you do trigger.
not pull the spray
gun trigger.
The diameter of Replace with a 1"
garden hose is too (25 mm) or 5/8"
small. (16 mm) garden
hose.
Water supply is re- Check garden hose
stricted. for kinks, leaks,
and blockage.
The water supply Open the water
is not sufficient. supply fully.
Spray tip has not Install desired
be installed onto spray tip to end of
the spray wand wand.
properly.
The water intake Remove filter and
filter is clogged. rinse in warm wa-
ter.