Bosch Uneo Notice Originale page 11

OBJ_BUCH-1695-002.book Page 11 Tuesday, April 2, 2013 10:59 AM
Protect the battery against heat, e. g., against
continuous intense sunlight, fire, water, and
moisture. Danger of explosion.
 In case of damage and improper use of the battery, va-
pours may be emitted. Ventilate the area and seek
medical help in case of complaints. The vapours can irri-
tate the respiratory system.
 Use the battery only in conjunction with your Bosch
power tool. This measure alone protects the battery
against dangerous overload.
 Use only original Bosch batteries with the voltage list-
ed on the nameplate of your power tool. When using oth-
er batteries, e.g. imitations, reconditioned batteries or
other brands, there is danger of injury as well as property
damage through exploding batteries.
 The battery is supplied partially charged. To ensure full
capacity of the battery, completely charge the battery
in the battery charger before using your power tool for
the first time.
 Read the operating instructions of the battery charger.
 Check the tight seating of the battery. Two locking lev-
els are possible.
 The battery charge-control indicator indicates the charge
condition of the battery for a few seconds when the On/Off
switch is pressed half or fully through. It consists of a
three-colour illuminating LED.
LED
Continuous lighting, green
Continuous lighting, orange
Continuous lighting, red
Flashing light, red
Symbols
The following symbols are important for reading and under-
standing the operating instructions. Please take note of the
symbols and their meaning. The correct interpretation of the
symbols will help you to use the machine in a better and safer
manner.
Symbol Meaning
Uneo: Cordless Rotary Hammer
Grey-marked area: Handle (insulated
gripping surface)
Article number
Read all safety warnings and all instruc-
tions
Bosch Power Tools
Symbol
Capacity
≥ 66 %
> 33 % —66 %
> 11 % —33 %
≤ 11 %
English | 11
Meaning
Before any work on the machine itself,
remove the battery from the power
tool.
Wear protective gloves
Always wear ear protection.
Wear safety glasses/goggles
Movement direction
Reaction direction
Next step of action
Prohibited action
Screwdriving
Drilling without impact
Hammer Drilling
Switching On
Switching Off
Low speed/impact rate
High speed/impact rate
Right/left rotation
Battery Charge Indicator
Tool holder
Apply a light coat of grease to the shank
end of the application tool
2 609 006 431 | (2.4.13)