Whirlpool W10837923A Guide D'utilisation Et D'entretien page 11

Troubleshooting
Before calling for service on your washer, please try the solutions suggested in this section.
If you experience
Water Leaks (cont.)
Check the following for
proper installation: (cont.)
Washer not performing as expected
Washer won't run
or fill; washer stops
working
All LEDs remain lit
Possible Causes
Fill hose washers.
Drain hose connection.
Check household plumbing for leaks
or clogged sink or drain.
Washer not loaded as recommended. Improper loading can cause basket to be out of alignment
Check for proper water supply.
Check proper electrical supply.
Normal washer operation.
Washer may be tightly packed.
Error code.
Make sure all 4 fill hose flat washers are properly seated.
Pull drain hose from washer cabinet and properly secure it
to drainpipe or laundry tub.
Do not place tape over drain opening.
Water can back up out of a clogged sink or drainpipe. Check all
household plumbing for leaks (laundry tubs, drain pipe, water
pipes, and faucets).
and cause water to splash off tub. See "Using Your Washer"
for loading instructions.
Both hoses must be attached and have water flowing to
inlet valve.
Both hot and cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet and that the polarity is correct.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not
interrupt cycle.
Press START (PAUSE/UNLOCK) for 3 seconds and wait for lid to
unlock. Remove several items, rearrange load evenly in basket,
and add detergent. Close lid and press START.
Do not add more than 1 or 2 additional items after cycle has
started to avoid tightly packing or unbalancing.
Try unplugging washer for 10 seconds and plug it back in
to reset the control.
Check for proper water supply per above.
Solution
11