Exo Terra LIGHT CYCLE UNIT Mode D'emploi page 6

2. Install fluorescent bulbs of the correct diameter and wattage by
inserting the bulb into the end cap so that the pins align with the
internal sockets. Push while inserting the bulb into the end cap to
ensure a positive connection.
3. Once the fluorescent bulbs have been inserted into the end
caps, position the bulbs on top of the metal screen cover of the
terrarium (not over the glass as UVB light does not penetrate
glass). Ensure that the surface of the screen cover is flat and
even so that the bulbs will not roll. Ensure that the bulbs are
positioned over the top metal screen portion of the terrarium and
NOT over any glass, plastic parts, or other flammable material.
Failure to do so could result in a possible fire hazard.
4. Keep unit out of reach of children. Keep unit away from curtains
or other flammable objects.
Exo Terra® Light Cycle Unit Installation Instructions -
T8/T10 Bulbs - North American Market
Recommended: For use with T8 (25 mm / 1" diameter) or
T10 (32 mm / 1 1/4" diameter) fluorescent bulbs.
Follow these instructions whenever installing T8 / T10
fluorescent tubes.
• This equipment is FOR INDOOR USE ONLY.
• Warning: Disconnect the plug of this light cycle unit, and any
other electrical equipment, used for the terrarium, paludarium
or aqua-terrarium before placing your hands in the water;
and/or performing any maintenance of any kind.

• Warning: Whenever installing, removing or changing
fluorescent tubes or maintaining, installing or removing the
Exo Terra® Light Cycle Unit or any other equipment, always
ensure that it is unplugged.
1. The light cycle unit housing provides a slot for suspending the
housing on a securely fastened screw head. The light cycle unit
housing should be located in a properly ventilated area, away
2. To install fluorescent bulbs of the correct diameter and wattage,
first determine which bulb diameter you wish to install (T8 or
T10). For T8 bulbs, adaptors are supplied for this purpose. The
adaptors should be snapped into the end caps before installing
the bulbs. T10 bulbs fit directly into the end caps supplied with
this unit.
from humidity,
moisture,
flammable
objects, and
fragile surfaces.
The light cycle
unit housing is
equipped with
ventilation slots
to allow heat
to escape, do
not obstruct
these vents in
any way and
ensure that any
dust or debris
is promptly
removed.