RCF L-PAD 6 Manuel Utilisateur page 6

FUNCTIONS
+48 V PHANTOM POWER ON-OFF switch: This switches the microphone input
phantom power on and off. It must be employed when condenser or electret
microphones are used.
OUTPUT LEVEL: These LEDs show the MAIN MIX OUTPUT level. Keep under CLIP level
to prevent generating distorted sounds or dangerous sound levels.
STEREO RETURN control: This defines the STEREO RETURN input signal level routed
to MAIN MIX output.
2TK IN control: This defines the signal level from the 2TK IN.
TO MAIN MIX/TO CONTROL ROOM switch: Defines where to route the signal coming
from 2TK IN: to MAIN MIX when in upper position, to CONTROL ROOM when pressed
(lower position).
PHONES/CONTROL ROOM control: This defines the signal level routed to CONTROL
ROOM output and PHONES output.
MAIN MIX KNOB: MAIN MIX level control.
HOW TO GET SOUND FROM A RCF mixing consoles MIXER
1. Turn your RCF mixer on.
2. Set all the knobs and controls to minimum position (0 or ‑∞)
3. Plug a microphone into the XLR connector ‑ MIC input of channel 1.
4. Adjusts GAIN according to MIC sensibility.
5. Connect your speaker system to the MAIN MIX output and turn it on.
6. Turn the channel knob up to "12 o'clock" position.
7. Carefully turn up the MAIN MIX fader to reach a reasonable sound level.
8. Enjoy the quality of your RCF mixing consoles mixer.
6
HOW TO IMPROVE THE SOUND
The RCF mixing consoles implements several powerful
tools to improve the sound quality of your music even
more.
EQ: A three‑band EQ is available on each mono
channel, while a dual‑band EQ is available on stereo
channels 3‑4 and 5‑6. Adjust these parameters to
subtract noise frequencies or magnify desired sounds.