Makita GA7063 Manuel D'instruction page 8

Pull the lever in direction of the arrow. Then tighten the
wheel guard with fastening the screw. Be sure to tighten
the screw securely. The setting angle of the wheel
guard can be adjusted with the lever.
2
1
► 1. Screw 2. Lever
To remove wheel guard, follow the installation proce-
dure in reverse.
Installing or removing depressed
center wheel or multi-disc
Optional accessory
WARNING:
When using a depressed center
wheel or multi-disc, the wheel guard must be
fitted on the tool so that the closed side of the
guard always points toward the operator.
WARNING:
Never use a grinding wheel which
is more than 6.5 mm (1/4") thick.
CAUTION:
Make sure that the mounting part
of the inner flange fits into the inner diameter of
the depressed center wheel / multi-disc perfectly.
Mounting the inner flange on the wrong side may
result in the dangerous vibration.
Mount the inner flange onto the spindle.
Make sure to fit the dented part of the inner flange onto
the straight part at the bottom of the spindle.
Fit the wheel/ disc on the inner flange and screw the
lock nut with its protrusion facing downward (facing
towards the wheel).
3
► 1. Lock nut 2. Depressed center wheel 3. Inner
flange
To tighten the lock nut, press the shaft lock firmly so
that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise.
► 1. Lock nut wrench 2. Shaft lock
To remove the wheel, follow the installation procedure
in reverse.
NOTE: In countries other than United States and
Canada, Inner flange 45 can be also used.
Installing or removing flex wheel
Optional accessory
WARNING:
flex wheel is on tool. Wheel can shatter during use
and guard helps to reduce chances of personal injury.
► 1. Lock nut 2. Flex wheel 3. Back up pad 4. Inner
flange
1
Follow instructions for depressed center wheel but also
use back up pad over wheel. See order of assembly on
2
accessories page in this manual.
8 ENGLISH
2
Always use supplied guard when
1
1
2
3
4