Publicité
Les langues disponibles
Les langues disponibles
1
5
2
3
4
5
Scope of supply
1 x RB-TT road book holder
1 x mounting plate
1 x handlebar remote control with wiring harness and
mounting material
1 x DIN on-board 12V power outlet, covered
1 x wiring harness to connect the socket
1 x wiring harness to connect the RB-TT road book holder 600.12.073.060
4 x M5 oval head screw
2 x M6x25 flat-head screw
2 x M6x30 flat head screws
4 x plastic spacer
4 x rubber element
4 x plastic sleeve
1 x 4xM5 motherboard
2 x M6 nuts
2 x M6 shims
Mounting
Loosen the 5 fixing screws on the left and right and remove both side cover
2
Detach the retaining tab
headlight forwards and pull the connector from the connector support.
Loosen the screw connections and connectors on the trip master and tacho-
meter and remove. Now remove the original trip master and tachometer
3
holder
.
NOTE:
The tachometer cannot be mounted if the road book kit is mounted.
Preparing the road book mounting plate
Remove the rubber elements from the original trip master holder and
mount them in the upper three holes in the road book mounting plate
Insert the on-board power outlet in the left part of the mounting plate and
fasten from behind with the nut included in the scope of supply.
Mount the four rubber elements included in the scope of supply in holes in
the mounting plate that are not countersunk and insert a plastic sleeve in
5
each element
.
Insert one M6 flat-head screw in each countersunk hole and slip a plastic
spacer on each screw from behind. The holes in the spacers are slightly
conical to facilitate the mounting.
600.12.073.000
600.12.073.050
600.12.073.080
600.11.042.000
600.11.042.050
600.12.073.070
with a screwdriver, tilt the windshield and
1
.
4
.
Publicité
