Teesa TSA3221 Mode D'emploi page 14

14
GRILL
1. Make sure the heating plates for grill are inserted into the device.
2. Apply a layer of vegetable oil or butter using brush for dough on both plates.
3. Put the product on the lower plate and close the cover.
Note: Do not use force while closing the device.
4. After some minutes (it depends on the recipe or user's preferences) open
the cover and carefully remove grilled products.
Notes:
• If the sandwich maker is used to toast ready-made waffles or sandwiches,
please make sure they fit the heating plates. If not, please cut them to fit
the plates.
• Ready-made waffles/sandwiches must be buttered on the outside.
• Do not use synthetic or low fat spread as it tends to overheat at a low-
er temperature forming dark brown residue that can cause the toasted
sandwich to stick to the plates.
SAFETY DURING REMOVING PRODUCTS FROM THE SANDWICH MAKER
• Remove ready products from the sandwich maker carefully as the heating
EN
plates are hot.
• Use wooden or plastic utensils not to damage the surface of the heating
plates.
• Remember to pull out the plug from power supply socket after using the
sandwich maker.
• Remember that products removed from the sandwich maker are hot. Be
careful not to get burned while eating them.
1. Remove the plug from the power supply socket and let the device cool
down before cleaning.
2. Wipe the plates with a cloth damped in hot, soapy water.
3. Dry the plates with a clean, dry cloth or a kitchen towel.
4. Do not use any abrasives or chemical agents to clean this product.
5. After each usage remove the accumulated crumbs and wipe the surface
of the heating plates with a paper towel to absorb and remove the fat
accumulated during roasting.
6. It is recommended to store the device in the original packaging to pre-
serve it from dust and humidity.
CLEANING AND MAINTENANCE
Owner's manual