Publicité
Les langues disponibles
Les langues disponibles
L
E
D
P
L
E
D
P
LP56LED-PRO
INSTRUCTION MANUAL
Thank you for purchasing the LED PAR-36. Every LED PAR-36 has been
well tested and has been shipped in perfect operating condition.
Introduction
The LED PAR-56 Pro IBIZA Light is part of a wider range of intelligent DMX
LED PAR CANS. This LED PAR-56 Pro is compact and light weight and very
easy to use. Ideal for rental or installation. The unit can be controlled by any
DMX controller or run in stand alone mode.
Safety Recommendations
Do not attempt any repairs yourself! Doing so will void your manufactures
warranty. In the unlikely event your unit may require service please
contact us.
To prevent or reduce the risk of electrical shock or fire, do not expose this
unit to rain or any moisture.
Please read this user manual carefully to familiarize yourself with the
basic operations of this unit.
Before plugging to power be sure the local power outlet matches with the
required voltage of the unit
Do not remove the cover under any circumstances in case you're not
qualified to do so.
Never connect to power when cover is removed.
Never use this unit if it becomes damaged.
Never connect this unit to any kind of dimmer- and/or power-pack.
If the unit will not be used for a long time, disconnect it from power supply.
Always mount this unit safe and stable, and make sure the area will have
proper ventilation.
Take care this unit will not mounted in areas close to heat sources such
as lighting fixtures, amplifiers, heat registers, stoves and radiators.
© Copyright Lotronic 2011
All manuals and user guides at all-guides.com
A
R
3
6
C
A
N
A
R
3
6
C
A
N
MOUNTING
The LP56LED-PRO is fitted with a dual
handle which allows him to place the unit on
a floor or another stable surface provided
there is adequate room for ventilation
RIGGING
It is important never to obstruct the fan or
vents pathway. Mount the fixture using, a
suitable "C" or "O" type clamp. Adjust the
angle of the fixture by loosening both knobs
and tilting the fixture. After finding the
desired position, retighten both knobs.
When selecting installation location, take into consideration lamp replacement
access and routine maintenance.
Safety cables must always be used.
Never mount in places where the fixture will be exposed to rain, high humidity,
extreme temperature changes or restricted ventilation.
If the external flexible cable or cord of this luminaire is damaged, it shall be
exclusively replaced by the manufacturer or his service agent or a similar
qualified person in order to avoid a hazard.
Fuse replacement:
Warnings: Disconnect the power cord before replacing a fuse and always
replace with the same type fuse.
With your hands, unscrew the fuse holder from its housing, remove the
damaged fuse from its holder and replace with exactly the same type of fuse.
Screw the fuse holder back in its place and reconnect power.
Exterior surface temperature under steady state conditions is 60℃.
2
Publicité
