Chopping - SilverCrest SMZ 260 G1 Mode D'emploi

Chopping

Note
Before using the appliance for the first time, clean it
thoroughly as per the instructions given in the chapter
"Cleaning".
Place the bowl 6 in the appliance base 9.
Place the blade holder 5 with the knife 7 on
the mounting 8.
Prepare the items to be processed by cutting large
pieces to a size that will fit in the bowl 6.
Place the food to be processed in the bowl 6.
Thereby, take note of the following table:
Filling
Foodstuff
quantity
Salami 130 g 3 x 5 secs.
Cheese
(Gouda,
100 g 4 x 15 secs.
young,
refrigerator
temperature)
Onions
100 g
Garlic
Carrots 100 g 3 x 5 secs.
Dried fruit 130 g 4 x 15 secs.
Almonds 50 g
Eggs
150 g 2 x 4 secs.
(hard boiled)
Walnuts 50 g
Ice cubes 100 g
Processing
Speed
time
Turbo
Turbo
pulsating Turbo
Normal
Turbo
coarse:
1 x 10 secs.
middle:
Turbo
2 x 10 secs.
fine:
3 x 10 secs.
Turbo
2 x 8 secs. Turbo
pulsating Turbo
Close the bowl 6 with the lid 4: Place it on the
bowl 6 so that the lugs on the lid 4 engage in
the slots on the bowl 6. Then turn the lid 4 so
that the lugs slide under the slots and the lid 4
locks into place.
Place the motor block 2 on the lid collar 3.
Press the motor block 2 downwards, as shown
in Figure B. The motor starts with the normal
operating speed.
To make use of the higher processing speed
"Turbo", press, in addition to the motor block 2,
the turbo button 1 and keep it pressed down,
as shown in Figure C.
Note
Should larger pieces of the contents collect on the
wall of the bowl while processing, lift the motor
block 2 from the lid collar 3. Shake the bowl 6
vigorously and then continue with the processing.
Before the processing, particularly hard foods must
be cut into smaller pieces (about 2cm). Otherwise,
the motor could block. With hard foodstuffs select a
pulsating processing. For this, press the turbo button
1 repeatedly for a short time (in addition to the
motor block 2). Should the foodstuff not be com-
pletely pulverised, you can either cut it into smaller
pieces or lift the motor block 2 from the lid col-
lar 3. Shake the bowl 6 vigorously and then con-
tinue with the processing.
When the contents have been sufficiently chopped,
release the motor block 2 and, if necessary, the
turbo button 1.
Unplug the power cable from the socket.
- 5 -