BST XA1000 Manuel D'utilisation page 3

1) POWER SWITCH
Used to switch the power amplifier on or off
2) & 5) CLIP/LIMIT LED
The clip led flash or lights on when the output signal starts distorting. In this case, decrease the level
3) VOLUME CONTROL
Gain control for the left channel, adjust the desired volume here.
4) VOLUME CONTROL
Gain control for the right channel, adjust the desired volume here.
6) COOLING VENTS
Perfect perforated thermal window style, easy to clean. These holes are using to refresh power amplifier. Don't obstruct this part
7) PROT LED
This led lights on when the power amplifier is on protection mode. In this case, check the speaker and connection
8) BRIDGE LED
This led lights on in bridge mode.
9) POWER LED
This led lights on when you switch the power amplifier on.
10) & 11) SIGNAL LED
Led signal indicator
1) INPUTS & LINK OUTPUTS
Connect to these sockets (XLR) the output of your mixer. The outputs links are to connect to another amplifier.
2) GND/LIFT
GND/Lift switch
3) MODE SWITCH
This switch is used to choose the operating mode of the power amplifier: stereo or bridge
4) BINDING POST OUTPUTS
Binding post speakers output, Red (+) and Black (-)
Note: in bridge mode, connect binding post + of channel 1 and binding post + of channel B to the speaker
5) POWER SUPPLY SOCKET
The main power supply.
6) TURNLOCK OUTPUTS
Connect these sockets to your speakers
© Copyright LOTRONIC 2016 XA1000 - XA600 - XA400 Page 3