Connecting The Condensed Water Drain For The Sc 39Xx And S 39Xx; Connecting The Condensed Water Drain Of The Indoor Unit; Connecting The Condensed Water Drain Of The Outdoor Unit - Qlima S(C) 3925 Manuel D'installation

9.

CONNECTING THE CONDENSED WATER DRAIN FOR THE SC 39XX AND S 39XX

MODELS.
9.1

Connecting the condensed water drain of the indoor unit.

Connect the supplied condensed water hose to the indoor unit fitting by sliding the condensed water hose
over the grommet of the hose of the indoor unit. Ensure that the height of any section of the condensed
water hose isn't higher than the height of the drain outlet and don't place the end of the hose in the water.
See Fig. 15.
Always direct the condensed water hose under the refrigerant piping, this prevents overflow of the con-
densed water container.
WARNING
• Make sure the drain hose is situated at the bottom of the pipe bundle. Positioning the hose at
the top side can cause overflow of the condensed water container.
• Let the drain hose slope slightly over the entire length so the condensed water can be
evacuated smoothly.
9.2

Connecting the condensed water drain of the outdoor unit.

Place the sealing ring on the drainage pipe and position the drain connector in the hole on the bottom side
of the outside unit. Connect the drainage pipe to a drain hose (not supplied). In this way the condensed
water that is accumulated in the heating mode of the air conditioning can be drained. See Fig. 16.
4
56
Picture 15
Picture 16