Hanau Spring-Bow Manuel D'utilisation page 7

Transfer Rod
Rubber Ring
Larger Hole
vertical lanDMarkS
13. Some HANAU Articulators are furnished with
™
an Orbitale Indicator as an anatomical simulation
of the patient's infra-orbitale notch. The top of the
Anterior Patient Reference (orbitale pointer) on
the Spring-Bow shall be aligned to the underside
of this Orbitale Indicator, Figure 14A.
Reference at Underside of
Orbitale Indicator
Should the Articulator not be equipped with an
Orbitale Indicator, the top of the Anterior Patient
Reference will be aligned to an acceptable sub-
stitute–the bottom of the Mounting Plate, Figure
14B.
Reference at Bottom of
Mounting Plate
Anterior Elevator
Thumbscrew
Elevating Pin
Figure 13
Orbitale Indicator
Figure 14A
Mounting Plate
Figure 14B
The HANAU-MATE
ences. A suitable substitute is to align the top of
the Anterior Patient Reference about one and one-
half millimeters (1/16") below the underside of
the Upper Member, Figure 14C.
Upper member
Reference 1/16" below
Upper Member
Mounting tHe Maxillary caSt
14. Rotate the Anterior Patient Reference to its stor-
age position at the side of the Bow.
15. The Bitefork index must be adequately supported
before placement of the maxillary cast and stone
or plaster mounting to the Articulator.
An accessory HANAU
003401-000 is offered to support the Bitefork and
maintain its position when adding the cast weight
and stone mix, Figure 15.
has none of these refer-
®
Figure 14C
Cast Support, Item No.
™
003401-000
Figure 15
5