Bosch Gravity-Rise T4B Consignes De Fonctionnement/Sécurité page 8

BM 2610027814 10-12_BM 2610027814 10-12.qxp 10/22/12 2:52 PM Page 8
Mounting Miter Saw to Stand
Note: Unfold stand to horizontal position
before mounting saw. (See page 9 for
instructions.)
1. Locate the tool mount assemblies, place
one (1) on the rail against the red tool
mount secondary stop, and rotate the lock
knob clockwise to the locked position, as
shown in figures 7 & 10.
2. Measure the width of the rear mounting
holes of the miter saw, place the other tool
mount on the rail with the same distance
apart as shown in figure 8, and rotate the
lock knob clockwise to the locked position.
3. Place miter saw on top of the tool mounts,
figure 9, align mounting holes by adjusting
rear sliding nuts and front swivel nuts,
figure 10. Be sure the front of the saw is
aligned to the front of both tool mounts.
4. Place one (1) 8mm flat washer (Q) onto
one (1) 8mm x 45mm bolt (L), insert
through miter saw base and loosely tighten
into tool mount.
5. Repeat step 4 of this procedure for the
remaining three (3) hole locations.
6. Securely tighten all four (4) bolts. Do not
over tighten.
Make sure the saw is
WARNING
properly oriented as shown
in the diagram to prevent any tipping hazard.
Look for the yellow warning decal on the
stand that states "operate saw from this side
only."
FIG. 9
Tool Mount
Secondary
Stop
FIG. 8
Rear
Sliding Nut
Front
Swivel Nut
Lock Knob
-8-
FIG. 7
FIG. 10