Bosch Gravity-Rise T4B Consignes De Fonctionnement/Sécurité page 10

BM 2610027814 10-12_BM 2610027814 10-12.qxp 10/22/12 2:52 PM Page 10
Remove Saw From Stand
(with tool mounts attached)
1. Rotate the lock knob to the unlock position
(see fig. 10, p8).
2. Locate the carry handles at the base of the
saw. Place one hand on the saw base
handle and the second on the saw's top
handle if available, as shown in figure 14.
Holding tightly, tilt the saw (with the tool
mounts still attached) toward yourself and
lift it from the stand.
Attach the Saw to the Stand
(with tool mounts attached)
1. Make sure the tool mount lock knobs on
each mount are in the open and unlocked
position (see fig. 10, p8).
2. Locate the carry handles at the base of the
saw. Place one hand on the saw base
handle and the second on the saw's top
handle if available. Lift the saw to the rail
assembly.
3. Line up the left tool mount next to the red
secondary stop on the rail assembly as
close as possible.
4. Tilt the saw until the front jaws of both tool
mounts are engaged to the rail. With both
hands on the saw handles, guide the saw
back to its level position on the rail (see
fig. 7, p8).
5. Rotate lock knob on each tool mount to the
locked position (see fig. 10, p8).
Be sure both tool mounts
WARNING
are in the locked position
before operating or transporting the saw.
Expansion Rail Adjustment
1. Loosen the locking knob located along the
side of the rail assembly, as shown in
figure 15.
2. Extend expansion rail to desired length
and retighten locking knob before
beginning work.
3. Repeat process for opposite side.
FIG. 14
FIG. 15
-10-