Bosch Gravity-Rise T4B Consignes De Fonctionnement/Sécurité page 11

BM 2610027814 10-12_BM 2610027814 10-12.qxp 10/22/12 2:52 PM Page 11
Work Height Support Adjustment
1. Loosen the locking knob located at the end
of the expansion rail, as shown in figure
16, and raise the work height support so it
is level with the table top of the attached
miter saw.
2. Retighten knob and repeat on opposite
side.
Repetitive Stop Adjustment
To raise the repetitive stop: Lift up and in
place as shown in figure 17.
To stow: Push the repetitive stop in toward
the rail assembly and down.
Repeat on opposite side.
Cam Lever Adjustment
In the event the cam lever for the support leg
loosens over time, tighten as shown in
figure 18.
1. Place the cam lever in the "Locked"
position.
2. Insert a flat head screw driver between the
bottom of M8 Nylock nut and the rail.
3. Rotate the cam lever clockwise to tighten
and counter-clockwise to loosen in order to
achieve the appropriate feel and stability of
the support leg.
FIG. 16
FIG. 17
FIG. 18
-11-