Num'axes PIE1060 Guide D'utilisation page 20

Switch to Video mode.
6. Customize the operating parameters
To enter the camera settings MENU, slide the switch to the SETUP position (the LCD screen will light up),
then press twice on the
Buttons functions in the settings MENU
Allows you to close the main menu or a sub-menu - Return to the previous page
Allows you to go up in a menu or increase a value by 1
Allows you to go down in a menu or decrease a value by 1
Allows you to go left
Allows you to go right
Allows you to open a selection or accept the selected settings
Confirm each change made to a setting by pressing the OK button. If the change is not
confirmed by pressing the OK button, the new setting will be lost when you exit the
menu.
Mode
PIR interval
PIR sensor sensitivity
Time Lapse
Cycle recording
Settings
Mode
PIE1060 - Indice B – Mars 2022
button.
Photo
00:20
High
OFF
ON
Programmable options (default settings in bold characters)
Photo | Video | Photo + Video
− Photo: the camera shoots only photos based on the configured "Photo
resolution" and "Multi-shot" settings.
− Video: the camera shoots only videos based on the configured "Video
resolution" and "Video length" settings.
− Photo + Video: upon the same trigger event, the camera shoots photo(s)
first then a video based on the configured "Photo resolution", "Multi-
shot", "Video resolution" and "Video length" settings.
IR LED brightness
Low power night capture
Operating periods
Auto
No capture
OFF
20/88