Installation/Removal - Delo AGM BATTERY Mode D'emploi

WARNING!
Risk of explosion and fire!
• Never use a car battery charger to charge your
motorcycle battery. They supply a charging
current that is too high and overcharge the
comparatively small motorcycle battery, which
can cause an explosion in the most extreme
cases.
• Only use chargers that are specifically designed
for AGM motorcycle batteries. The charging
current must not be higher than 10% of the
battery capacity (e.g. for a battery capacity of
10 Ah, a maximum charging current of 1 amp).
• Charging voltages of up to 14.8 V are no problem
for DELO AGM batteries; the optimum
end-of-charge voltage is 14.7 V. Please also note
the individual information provided on the top of
the battery in this regard.
After charging, firmly secure the battery in the clean battery
compartment.

5.3 | Installation/removal

Before you remove the old battery, switch off all the electrical
devices on your motorcycle. Disconnect the earth connection (–)
first of all, then the positive terminal (+), and then remove the old
battery.
After you have ensured that the DELO AGM battery corresponds
to the features of the original battery, install the DELO battery
in the appropriate location. The battery cables are connected in
reverse order – remove the sticker and connect the positive cable
to the positive terminal (+) first of all, and then connect the earth
27