Miele 06572532 Notice De Montage page 6

Produktgruppe 512
6 von 30
Note
The kit, Mat. no. 09885130 for PW 6241, PW 6321 contains the following:
1 electronic module EZL 230(a), module 2 (liquid dispensing 7-12)
1 adapter EV 230
1 electronic module holder
8 spacers (for electronic module EZL 230(a) fastening)
1 coding plug MFM 2-5, AWG
1 wiring harness 48X-41X, AWG
1 wiring harness 49X-46X, AWG
1 wiring harness 51X-52X-101X, AWG 20
1 wiring harness 47X-100X, AWG 20
1 connection wire, green-yellow 240 x 96, AWG 18
1 accessory module
1 wiring diagram module 2, Mat. no. 09021420
1 wiring diagram Mat. no. 09882800
Fitting instructions - Module 2, liquid dispensing 7 - 12, Mat. no. 06572532.
List of illustrations:
Fig. 1: Fitting cable throughfeeds on connection strip
Fig. 2: Fitting electronic module EZL 230(a)
Disconnect the machine from the gas (if applicable) and electric mains and ensure utilities cannot be switched on again in error.
Remove 1 screw from each side of the lid at the top of the machine.
Lift the front of the lid slightly, slide it to the rear and thus release the centring cones at the rear of the lid from the connection strip.
Remove the lid upwards.
Fit the electronic module EZL 230(a), adapter EV 230, Fig. 2, and cable throughfeeds, Fig. 1.
Connect the electronic module EZL 230(a) and adapter EV 230, Fig. 2, in accordance with the wiring diagram.
Modify the connection for EZL 230 46X from electronic module 2N1L to 3N1L.
Lay and connect the wiring harnesses as follows:
Warning!
The power and control wiring harnesses must be laid separately in order to avoid interference in the control circuit (electromagnetic
compatibility).
Excess cable should be gathered such that current flows in opposite directions and tied in order to avoid any antenna effect.
Connect the coding plugs as follows:
Connect coding plug MFM 2-5 to module 2 (liquid dispensing 7-12) EZL 230(a) - 42X, PIN 2-5.
Register module 2 (liquid dispensing 7 - 12) as follows:
Via Service level Main menu
button Activate the disk symbol to save the setting.
Switch on the dispensing display.
Via Service level Main menu
Back button (to go back one level)
Note
If the dispensing display is activated, the operator can activate and deactivate dispensing. If the dispensing display is not activated,
dispensing activation and deactivation is controlled by the programme in operation only.
To quit the service mode, switch off the machine.
06.02.2014 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Service settings Module registration
Service settings Basic settings
Activate the disk symbol to save the setting.
Umbau- und Montageanweisung
EZL with coding 2 Module registration?
Dispensing Dispensing display: Off
M.-Nr. 06572532
OK
On OK button