Information About The Device - Trotec TTK 655 S Manuel D'utilisation

Information about the device

Description of the device
This device uses the principle of condensation to au-
tomatically dehumidify rooms.
The fan sucks damp room air through the air inlet (1),
the air filter (10), the evaporator and to the condenser
located behind it. The air is cooled at the cold evapo-
rator until it is below the dew point. Water vapour con-
tained in the room air precipitates on the evaporator
fins as either condensation or frost. The dehumidified,
cooled air is rewarmed at the condenser and blown
out at a temperature of approx. 5 °C above room tem-
perature. The drier air which is prepared in this way
mixes with the air in the room. The relative humidity
in the room where the device is positioned is reduced
as air constantly circulates through the device. De-
pending on the air temperature and the relative hu-
midity, the condensed water either drops continuously
or only during the defrost phase into the condensation
tray. The condensation is fed from the device through
the condensation drain hose connected to the hose
connector (3) into an external container or drain.
The condensed water can also be diverted by means
of a retrofitted condensate pump (see chapter "Install-
ing the condensate pump (optional)").
The device has a control panel (6) for operating and
controlling the functions.
The device can reduce the relative humidity of a room
by up to approx. 32 %. Because of the heat radiation
which is tied up in operation, the room temperature
can rise by approx. 1-4 °C.
EN
Device depiction
9
8
7
6
5
No. Operating element
1 air inlet
2 connection for optional condensate pump (inside the
device)
3 hose connector for condensation drain hose
4 feet
5 wheels
6 control panel
7 air outlet
8 carry handle
9 transport handle
10 air filter
Operating Manual – Dehumidifier TTK 655 S
T T K
6 5 5 S
1
2
3
4
10
B - 2