Braun Silk-epil EverSoft 2330 Mode D'emploi page 13

7. Clean the OptiTrim attachment
with the brush.
8. In order to clean the shaver head,
remove the shaving foil frame
To do so, press the release bars
on the front and back and pull
7c
it off.
9. Carefully tap the shaving foil
frame on a flat surface.
10. Brush out the cutter block
well as the area below the cutter
block.
11. N.B.: The shaving foil is a very
delicate part that must not be
cleaned with the brush.
12. We recommend that you put a
drop of light machine oil along the
length of the trimmer every 3
months.
13. Put the shaving foil frame back on
and snap it into place.
14. Replace the OptiTrim attachment
because it also serves as a
protective cap.
Note: Do not use the shaver head
with a damaged shaving foil.
Replacing the shaving parts
The shaving foil and the cutter block
are precision parts that wear out with
the time. Have the shaving foil frame
and the cutter block replaced when
you notice a reduced shaving per-
formance even after cleaning the
shaver head.
Subject to change without notice.
This product conforms to the
EMC-Directive 89/336/EEC
and to the Low Voltage Regulation
. (73/23 EEC).
7b
At the end of the product's
useful life, please dispose of
it at appropriate collection
as points provided in your country.
7d
13