8
www.aeg.com
4. DAILY USE
WARNING!
Refer to Safety chapters.
4.1 Operating the hob
You operate the hob with the knobs of
the oven and control panel of the hob.
The "Daily use" chapter for the oven tells
how to operate the hob.
4.2 Automatic Switch Off
The function deactivates the hob
automatically if:
• all cooking zones are deactivated,
• you do not set the heat setting after
you activate the hob,
• you spill something or put something
on the control panel for more than 10
seconds (a pan, a cloth, etc.). An
acoustic signal sounds and the hob
deactivates. Remove the object or
clean the control panel.
• you do not deactivate a cooking zone
or change the heat setting. After
some time
deactivates.
The relation between the heat setting
and the time after which the hob
deactivates:
Heat setting
, 1 - 2
3 - 4
5
6 - 9
4.3 Activating and
deactivating the outer rings
You can adjust the surface you cook to
the dimension of the cookware.
Use sensor field:
To activate the outer ring: touch the
sensor field. The indicator comes on.
comes on and the hob
The hob deacti-
vates after
6 hours
5 hours
4 hours
1.5 hour
To activate more outer rings: touch the
same sensor field again. The subsequent
indicator comes on.
To deactivate the outer ring: touch the
sensor field until the indicator goes out.
When you activate the zone
but do not activate the outer
ring the light that comes out
from the zone may cover the
outer ring. It does not mean
that the outer ring is
activated. To see if the ring
is activated check the
indicator.
4.4 Automatic Heat Up
If you activate this function you can get a
necessary heat setting in a shorter time.
The function sets the highest heat setting
for some time and then decreases to the
correct heat setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: turn the knob clockwise until
comes on. Immediately set the correct
heat setting. After 3 seconds
on.
To deactivate the function: turn the
knob counterclockwise.
4.5 Timer
Count Down Timer
You can use this function to set how long
the cooking zone should operate for a
single cooking session.
First set the cooking zone then set the
function. You can set the heat setting
before or after you set the function.
To set the cooking zone: touch
again and again until the indicator of a
necessary cooking zone comes on.
To activate the function: touch
the timer to set the time (00 - 99
minutes). When the indicator of the
comes
of