Nice OXILR Mode D'emploi page 4

2
INSTALLATION AND CONNECTION
The receiver must be connected to the control unit by inserting it through the relevant slot:
01.
Before inserting (or removing) the receiver,
disconnect the power supply to the control unit.
02.
Connect the antenna supplied to terminal 1 of the re-
ceiver, as shown in Fig. A. Alternatively, if the radio
signal reception must be improved through the instal-
lation of an external antenna with a coaxial cable with
50Ω impedance (type RG58), the coaxial cable must
be connected directly to terminals 1 and 2 of the
receiver (Fig. B), ignoring the "antenna" terminal (if
present) on the control panel.
03.
Insert the receiver through the relevant opening on
the control unit.
3 - English
OFF
Fig. A Fig. B