Nice OXILR Mode D'emploi page 3

operations, such as, for example: the memorisation of new transmitters without having to access the receiver,
and the use of the O-View programmer through its "BusT4" connection to the control unit.
– This receiver can be used solely with control units equipped with "SM"-type plug connector (verify the most
suitable control units on the Nice product catalogue or on the www.niceforyou.com website).
– This receiver automatically recognises the characteristics of the control unit on which it is installed and self-
sets in the following way:
- If the control unit manages the "BusT4", the receiver makes available up to 15 different commands.
- If the control unit DOES NOT manage the "BusT4", the receiver makes available up to 4 different commands.
Important! – In both cases, the number and diversity of the available commands depend on the type and
model of the control unit adopted. The "Table of commands" of each control unit is shown in the respective
instruction manual.
English - 2