emitor Satlook Micro G2 Manuel D'utilisation page 21

Bands will be the same, but if a different UniCable is used, then the UniCable LNB must
be re-selected to so that the User Bands can be found. The User Bands are assumed to
be 100 MHz wide. (Using the Spectrum mode will show how wide the User Band is and
whether it is symmetrically about the tuning frequency.) In the Digital mode, retuning is
performed every time the frequency is changed using the knob or the Band/Polarisation
is changed. In the Spectrum mode, no retuning is performed while the cursor is within
the UniCable Band of 100MHz. To force the retuning, exit the Spectrum mode and re-
enter. Entry to the Digital Mode and Spectrum mode force UniCable re-tuning. During
UniCable LNB use, the 13V/18V and the 22kHz signal indications are still used for
Polarisation and Band selection, but they are not actually imposed on the LNB cable.
Modulation
This function is only available with the Satlook HD. It sets the modulation type that will
be tried when in the Digital Mode. This can be used with the search function to find only
transponders that are DVB-S or DVB-S2. The BlindTune algorithms used will search for
Symbol Rates from 15000 to 30000. In addition, the Low Symbol rate option can be
enabled to allow the search for Symbol Rates from 1000 to 15000. This will search for
QPSK only in this region. This option adds extra time to the BlindTune algorithm so that
when these low symbol rates are not needed, it should be turned off. This setting is a
power up parameter.
StartUp Mode
The mode on power up can be chosen for the Satlook G2 / HD. This setting is a saved
parameter.
21