Operating Instructions - Ritter volcano 3 Mode D'emploi

English
Unfold the graphics in the front
of the book.
Please read these instructions
thoroughly before you start to
use the toaster. Keep these
operating instructions in a safe
place and ensure that they
are included with the toaster if
passing it on to a third party.
Alternatively, these operating
instructions are available at
www.ritterwerk.de.
INTENDED USE
This toaster is intended to be
used exclusively for the toast-
ing of sliced bread and bread
rolls that are suitable for toast-
ing in a domestic setting and on
a domestic scale.
If the appliance is used for a
purpose other than this, or if it
is operated incorrectly, severe
injuries may occur or the toaster
may be damaged. All warranty
and liability claims will be ren-
dered null and void in this case.
FUNCTIONS
The toaster includes an auto-
centring function (see below).
Toasting
The toasting function allows
you to toast bread to your
desired toasting degree.
Reheating
The reheating function allows
you to reheat cold bread that
has already been toasted.
The reheating process takes
approximately 30 seconds.
Defrosting
The defrost function allows you
to thaw frozen slices of bread
and toast them to the desired
degree in a single process.
12
Warming­up
The integrated bread and roll
rack allows you to warm up
bread rolls for an oven-fresh
taste.
LED DISPLAY
The LED display provides infor-
mation about the function that is
currently in use:
Toasting
When you begin toasting,
the LED indicators light up to
indicate the toasting degree
selected. You can configure
nine different toasting degrees.
As toasting progresses, the
LED indicators switch off one
by one to allow you to estimate
the remaining toasting time.
Reheating
The LED indicators light up
and switch off one by one
when the reheating process is
completed.
Defrosting
During defrosting, the LED
indicators flash to indicate the
toasting degree selected. The
indicators do not switch off
until the bread has been fully
defrosted and toasted.
Warming­up
When the warming-up process
begins, the LED indicators
light up to indicate the toasting
degree selected. As warming-up
progresses, the LED indicators
switch off one by one to allow
you to estimate how much
warming-up time remains.
BEFORE USING THE
APPLIANCE FOR THE
FIRST TIME
Preparation
• Clean the toaster before
allowing it to come into contact
with any food (see CLEANING).
• Set the toaster down on a
flat, non-skid surface close to a
mains socket.
• Plug the mains cable (7) into
the socket.
• Set the toaster to "Toast"
three times without inserting any
bread into the toasting slot (see
USING THE TOASTER).
Ensure that there is sufficient
ventilation in the room (for
example, by opening a window).
USING THE APPLIANCE
Preparation
• Ensure that the crumb
tray (8) is in its designated slot.
The toaster is designed so that
regular bread that is suitable
for toasting will turn golden
brown when a medium toasting
degree is selected.
Toasting to golden brown
brings out the taste of the
bread perfectly.
The result of toasting may differ
depending on the type and
freshness of the bread.
Note:
Consuming bread that has
been toasted to an excessive
degree may be harmful to
health.