Weka HD16 Notice D'utilisation page 16

Sound emission values determined according to EN 60745-2-1.
The typical A-weighted sound pressure level is 88 dB(A).
The typical A-weighted sound capacity level is 99 dB(A).
Uncertainty K =3 dB.
Vibration total values a (triax vector sum) and uncertainty K determined according to EN 60745:
Drilling into concrete: a <2,5 m/s , K=1,5 m/s .
The vibration level given in this information sheet has been measured in accordance with a standardised
test given in EN 60745 and may be used to compare one tool with another. It may be used for a
preliminary assessment of exposure. The declared vibration emission level represents the main
applications of the tool. However if the tool is used for different applications, with different accessories
or insertion tools or is poorly maintained, the vibration emission may differ. This may significantly
increase the exposure level over the total working period. An estimation of the level of exposure to
vibration should also take into account the times when the tool is switched off or when it is running but
not actually doing the job. This may significantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the effects of vibration such as: maintain
the tool and the accessories, keep the hands warm, organisation of work patterns.
4. P R E P A R A T I O N
Make sure that the machine did not get damaged by the transport. Check that the rated voltage indicated
on rating plate conforms with main voltage.
4.1 Electrical connection
4.1.1 230 ~
Connect the HD16 via the frequency converter FU6U and via the adapter cable only on a properly
earthed shockproof socket. If required use only high quality extension cords with sufficient cross section.
Up to 100m length - 3G1,5 quality, e.g. H 07BQ-F or H 07RN-F
4.1.2 400 3 ~
Connect the HD16 via the frequency converter FU6 only on a properly earthed shockproof socket. If
required use only high quality extension cords with sufficient cross section.
Up to 100m length - 4G1,5 quality, e.g. H 07BQ-F or H 07RN-F
Take care that the extension cord is not rolled up on use for reaching a sufficient heat
removal. Consider that the HD16 takes the maximal power from the electrical mains.
Therefore do not connect other users to the concerning fuse, as the mains and the fuse
will then be overloaded. Please take care that the HD16 is only connected to an earthed
16A CEE socket. If you operate the machine at a higher assured socket, you risk in case
of any fault the total burning of the electronic. According to the relevant regulations
machines in the commercial sector may be operated only by means of a building power
distribution system. Ensure that a residual current circuit breaker of type B, or B + is
integrated, since an FI type A can fail in the event of a fault. By the high leakage current
the machine can electrify when touched, if the ground line is not connected correctly. In
this case absolutely disconnect the mains plug immediately and check the ground wire.
HD16 and FU6 can be used at a generator or a transformer provided by the construction site, if following
conditions are kept:
- operating voltage within +5% and –10 % to nominal voltage
- integrated automatic voltage controller with start amplification
- frequency 50 – 60Hz; max. 65 Hz
- AC voltage, power output at least:
230V ~
400V 3~
Do not use any other devices at the generator/transformator at the same time. The switching on and off
of other devices can cause undervoltage and / or over voltage peaks that can damage the machine.
4.2 Water supply
h
2
h
- 4,5 kVA
- 4,5 kVA
2
13