Polaroid OneStep+ Manuel D'utilisation page 15

1. Turn the
camera on/off
To turn the camera on, slide
the power switch into the ON
position (down). The flash
charging LED on the back pan-
el will start blinking to charge
the flash, and the remaining
film counter on the top of the
camera will light up to indicate
that the camera is switched
on, and show the amount of re-
maining film if a film cassette is
loaded. To turn the camera off
again, return the power switch
to the OFF position.
2. Load the film
Slide the film door latch to the
right to open the film door.
Push the film cassette all the
way in, with the film's darkslide
facing up.
Note Please check
individual film packaging
for development time,
handling and storage
details.
3. Close film door
When you close the film door,
the darkslide will eject from
the camera automatically,
underneath the film shield.
The plastic film shield is
designed to protect images
from light as they develop — it
should not be removed. Take
the darkslide out from under
the film shield and let the film
shield roll back up. If the dark-
slide has not ejected, remove
the film pack and re-insert it,
making sure it is pushed all
the way to the back of the
camera.
4. Set the Flash
& Lighten/Darken
Flash The camera flash will
trigger by default when you
shoot with the OneStep+. To
shoot without the flash, press
and hold the flash override but-
ton on the back panel as you
press the shutter button.
Warning Shooting without
flash will reduce camera
performance and picture
quality in most lighting
situations except brightly-
lit, sunny environments.
We recommend always
shooting with flash.