Installing The Grill Covers; Solid Footing - Martin Logan Motion 20 Mode D'emploi

mend that you aim them towards the primary
listening position.

INSTALLING THE GRILL COVERS

To install this speaker's magnetic grill covers simply
move them into place (Fig. 6).

SOLID FOOTING

With the use of the included spikes, your speakers
will be firmly planted on the floor, bass will tighten,
and imaging will become more coherent. To avoid
floor damage, do not implement the spikes until
you are secure in the positioning. The included
spikes use a standard 1/4 - 20 thread.
Spike Installation Instructions (Fig. 7):
1) Carefully lay your speaker on its side.
2) Remove existing feet or spikes. Thread new
spikes into holes and screw them in all of the
way. If the speaker does not sit level loosen
one spike until level is achieved.
3) Tighten the jam nut snugly by hand. Do not over
tighten the nut.
4) Right the speaker. Caution: Make sure your
hands and any cabling are clear of the spikes.
Do not slide speaker as spikes are sharp and
can damage your floor or carpet.
5) Adjust to level by rotating spikes. Tighten the
jam nut securely when satisfied that speaker is
level. Caution: "Walking" the speaker may result
in a broken spike.
8
Fig. 6
Fig. 7