Publicité
Les langues disponibles
Les langues disponibles
•
Pull out the plug and/or remove the
battery before making any adjustments,
changing accessories or putting the power
tool away. These safety precautions
reduce the risk of accidentally starting the
power tool.
•
Store power tools out of the reach of
children when not in use. Never allow
children, or anyone who is unfamiliar with
the power tool and these instructions,
to use the tool. Power tools are dangerous
if used by inexperienced persons.
•
Maintain and take good care of power
tools. Check before use that moving parts
are properly adjusted and do not jam,
and that no parts are damaged. Check for
other factors that could affect the
functionality of the product. Have the
product repaired before using it again.
Many accidents are caused by poorly
maintained power tools.
•
Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to jam
and are easier to control.
•
Use the power tool, accessories and bits
etc., in accordance with these instructions,
taking into account the actual working
conditions and the work that is to be
done. It can be dangerous to use power
tools for purposes other than those for
which they are intended to be used.
•
Do not use the product if a handle or
safety device is dismantled or damaged.
Do not dismantle the product or attempt
to modify or repair it – risk of personal
injury and/or material damage.
•
Look around the work area for potential
risks that you might not notice when the
product is in use.
•
Do not use the product when other
persons, especially children, or pets, are in
the vicinity.
•
Be careful when working on slopes.
•
Always maintain a firm footing and good
balance, and walk slowly.
•
Work across slopes, never up and down.
•
Be very careful when changing direction
– risk of tripping.
•
Do not mow very steep slopes.
•
Be very careful when going backwards or
pulling the product towards you.
•
Do not tilt the product when starting the
motor.
•
Stand at a safe distance behind the handle.
•
Keep your hands and feet away from
moving parts when starting the motor.
•
Switch off the product before tilting it and
before moving it, for example to and from
the lawn or over paths.
•
Never cross over gravel surfaces with the
motor running – risk of stones flying out.
•
Switch off the product and wait until all
moving parts have completely stopped
before lifting or carrying the product.
•
Switch off the product and wait until all
moving parts have completely stopped
before adjusting the cutting height.
•
Never open the ejector flap when the
motor is running.
•
Switch off the product and wait until all
moving parts have completely stopped
before removing the grass catcher. Firmly
replace the grass catcher after emptying.
•
If possible, avoid cutting wet grass.
•
Do not use the product in explosive
environments, for example near
flammable liquids, gas or dust. The
product produces sparks, which can ignite
dust and fumes.
•
Never leave the product unattended when
plugged in.
•
Use the product carefully. Never run with
the product.
•
Be careful to make sure your fingers do
not fasten between the blades and fixed
parts of the product – risk of serious
personal injury.
•
Do not mow wet ground, near streams/
ditches or steep slopes – risk of losing
control.
EN
39
Publicité
