SmartSun MasterSun Phantom Manuel D'instruction page 34

7.
ADDITIONAL
FUNCTIONS
7.1 CONTROLLER-MOTOR SYNCHRONIZATION
To synchronize the control with the motor, the following steps must be followed:
• Disconnect the motor from the power supply and wait more than 10 seconds to plug it back
in. The motor will beep.
• Press the "P2" button on the remote control twice, located on the back next to the battery. A
beep is heard for each press.
• Then press the UP or DOWN button on the remote. Depending on which of the 2 is pressed,
the motor will rotate in one direction or another. 3 beeps will be heard.
• Configuration OK.
7.2 CHANGE THE CONTROL OPERATION TO MAKE THE PUSHING OR
CONTINUOUS MOVEMENT
This option allows the motor to respond to the command controls continuously if we press once,
or by pressing each time we operate the command.
• Without disconnecting the motor.
• Press the "P2" button on the remote once, located on the back next to the battery. A beep is
heard.
• Press the UP button.
• Press the "P2" button on the remote once again. A beep is heard.
• Configuration OK.
7.3 ADD AN ADDITIONAL REMOTE
This option allows the motor to be controlled by several controls. Sin desconectar el motor.
• Without disconnecting the motor.
• Press the "P2" button twice on the remote already programmed. Motor beep is heard.
• Then press the "P2" button one time on the remote to add.
• Setting OK.
34