General Notes On The Manufacture Of The Awning - SmartSun MasterSun Phantom Manuel D'instruction

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

2.
GENERAL NOTES ON THE
MANUFACTURE OF THE
AWNING
The fabric may have small imperfections, despite the sophisticated production. These, however,
do not diminish the quality of the fabrics in any way.
We would like to expressly draw your attention to the following peculiarities of the manufacture
of a tarpaulin:
• The folds may be created during fabrication and when folding the fabric of the awning. In the
course of this process, especially in the lighter colors, surface defects can appear in the fold
(pigment displacements), with darker areas with a backlight (such as the ground strip). This
does not diminish the value or performance of the awning.
• Rainproof, acrylic and polyester sun protection: awning materials are impregnated with water
repellents and at a minimum incline of 14 degrees can withstand light and weak rain. In case
of heavy rain, the awning must be removed to avoid damage. Awnings that are wet wrapped
should be extended again as soon as possible for drying.
• Imperfections in the weave of the fabric (like small knots in the thread that compose it) do not
diminish the performance of the canvas.
• Waves in the seam or stitches on the canvas are caused by fabric stress (eg patterns, waffles
or fishbone).
• The fabric thread does not have to be the same color as the part of the fabric that contains
the seam.
10

Publicité

Table des Matières
loading

Table des Matières