FALMEC QUASAR Mode D'emploi page 22

The manufacturer is not liable for any inaccuracies in this booklet resulting from printing or
transcription errors. The manufacturer reserves the right to modify its products as it consid-
ers necessary or in the interests of the user, without compromising their essential safety and
operating characteristics.
O
MOUNTING INSTRUCTIONS, RANGE HOODS
Phase 1
- Place the support bar (A-fig. O2) on the wall, at a height from the cooker resulting from the
sum of the quotas X+518 mm.
- With a spirit level, verify the horizontal alignment and mark 2 drilling points at the ends of the
bar.
- Drill, insert two ø 8mm expansion plugs and fasten the bar with the relative screws.
Phase 2
- Remove the perimeter suction panel, the metal filters and the inside panel (C) according to
the indications in figure H3 and 01.
- Hook the hood to the support bar (fig. O3).
- Adjust the alignment of the hood, using the fixing screws (fig. O3). The upper screw (B)
adjusts the distance from the wall, the lower one (C) the vertical sliding.
Phase 3
- To prevent the hood from falling due to pressure below, fasten it to the wall with an expansion
plug and relative screw using the appropriate holes on the back of the hood (fig. O3).
- For the exhaust version, connect the outlet fittings of the fan to the external exhaust, using a
suitable tube.
- Carry out the electric connection only after having disconnected the electric power supply
of the hood.
Phase 4 (optional) (fig. O5)
- Insert the extension (H) in the chimney (G) and fasten it to the body of the hood using the 8
screws (V2).
- Slide the extension (H) until it reaches the desired height.
- Having found the ideal position, place the bracket (L) on the wall, verify the horizontal align-
ment with a spirit level and mark 2 drilling points at the ends.
- Drill, insert two ø 4mm expansion plugs and fasten the bracket (L) with the relative screws.
- Fasten the extension (H) to the bracket (L) using the screws (M).
Phase 5
- Put the inside panel (C), the metal filters and the perimeter suction panel back on the hood.
- Power the hood complying with standards in force (sec. D).
20