Shure INTELLIMIX P300 Guide De L'utilisateur page 77

P300 Hardware
input usb
output
① Mobile Input
TRRS mobile input connects to a mobile device. Supports bidirectional
audio with a TRRS cable. Sends audio in to the P300 with a TRS
cable.
Note: See the cable requirements topic for additional information
Pin Assignments:
Штырь Аудиовход (Левый)
Кольцо 1 Аудиовход (Правый )
Кольцо 2 земля
Втулка Аудиовыход (To Phone)
Note: Left and Right audio signals are summed to a mono signal.
② Audio Inputs (Block Connector)
Balanced audio input connects to an analog audio device. Set the
analog input level in the web application to match the output level of
the analog device.
Input sensitivity:
Line (+4 dBu)
Aux (-10 dBV)
Block Pin Assignments:
Audio +
Audio -
Audio ground
③ Chassis Ground Screw
Provides an optional connection for microphone shield wire to chassis
ground.
④ Audio Outputs (Block Connector)
Balanced audio output connects to an analog device. Set the output
level in the web application to match the input sensitivity of the analog
device (Line, Aux, or Mic level).
Audio +
Audio -
Audio ground
⑤ USB Port
Connects to a computer to send and receive up to 2 input or output
audio channels.
⑥ Dante Network Port
Connects to a network switch to connect Dante™ audio, Power over
Ethernet (PoE), and data from the control software.
⑦ Reset Button
Resets the device settings back to the factory default
Rear Panel
sig/clip
input 1
input 2
output 1
output 2
reset
⑧ LED Indicators
Power: Power over Ethernet Plus (PoE+) present
Note: Use a PoE+ injector if your network switch does not supply PoE+.
Network: Ethernet connection active
Network Audio: Dante™ audio present on the network
Note: Error details are available in the event log in the web application.
Network Audio LED Behavior
LED Status
Off
Green
Red
Encryption:
LED Status
Off
Green
Red
USB Audio
LED State
Off
Green
Red (flashing)
⑨ Level Indicators (Signal/Clip)
Tri-color LEDs indicate the audio signal level for the analog channels
and connectivity status for the USB channel. Adjust output levels in the
web application to avoid clipping.
Analog Input/Output
LED State
Off
Green
Yellow
Red
Note: The input and output LEDs stay off when metering is set to После
регулятора and the channel is muted in the web application.
77
Front panel
Power
Network
Network Audio
Encryption
USB
Activity
No active signal
Device is operating successfully
Error has occurred. See event log for details.
Activity
Audio not encrypted
Encryption enabled
Encryption error. Possible causes:
• Encryption is enabled on one device and not on another
• Passphrase mismatch
Status
No USB device connected
USB device operating successfully
Problem detected with connected USB audio device
Audio Signal Level
less than -60 dBFS
-60 dBFS to -18 dBFS
-18 dBFS to -6 dBFS
-6 dBFS or more
power
network
network audio
encryption
usb