Shure INTELLIMIX P300 Guide De L'utilisateur page 11

Dante Audio & Controller
Port TCP/UDP
162 udp
[319-320]* udp
2203 udp
4321, 14336-14600 udp
[4440, 4444, 4455]* udp
5353 udp
[8700-8706, 8800]* udp
8751 udp
16000-65536 udp
*These ports must be open on the PC or control system to access the device through a firewall.
These protocols require multicast. Ensure multicast has been correctly configured for your network.
†
Specifications
Analog Connections
Input (2) 3-pin block connector (Active Balanced)
Output (2) 3-pin block connector (Impedance Balanced)
Mobile (1) TRRS 3.5 mm (1/8")
USB Connections
(1) USB 2.0, Type B
Single port carries 2 input and 2 output channels (Summed mono)
Network Connections (Dante Digital Audio)
(1) RJ45
10 Dante input channels, 2 output channels
Polarity
Non-inverting, any input to any output
Power Requirements
802.3 at Type 2 (PoE Plus), Class 4
Power Consumption
17.5 W, maximum
Weight
1710 g (3.8 lbs)
Dimensions
H x W x D
4 x 21 x 22.6 cm (1.6 x 8.3 x 8.9 in.)
control application
HTML5 Browser-based
Operating Temperature Range
−6.7°C (20°F) to 50°C (122°F)
Storage Temperature Range
−29°C (-20°F) to 74°C (165°F)
Thermal Power Dissipation
Maximum 17.5 W (60 BTU/hr)
typical 14.6 W (50 BTU/hr)
Audio
Frequency Response
+1, -1.5 dB
20 to 20,000 Hz
Dante Digital Audio
Sampling Rate 48 kHz
Bit Depth 24
Protocol Description
SNMP Used by Dante
PTP Dante clocking
†
Custom Required for packet bridge
Dante Dante audio
Dante Dante audio routing
mDNS Used by Dante
†
Dante Dante Control and Monitoring
Dante Dante Controller
Dante Used by Dante
11
USB Audio
Sampling Rate 44.1, 48 kHz
Bit Depth 16, 24
Latency
Does not include Dante latency Dante 1-8 in to Dante out (AEC enabled)
Dante 1-8 in to Dante out (AEC disabled)
Dante 9-10 in to Dante out
Analog in to Analog out
Analog Connections (Block Connectors)
Dynamic Range
20 Hz to 20 kHz, A-weighted, typical
Analog-to-Dante 113 dB
Dante-to-Analog 117 dB
Equivalent Input Noise
20 Hz to 20 kHz, A-weighted, input terminated with 150Ω
Line -86 dBV
Aux -98 dBV
Total Harmonic Distortion
@ 1 kHz, 0 dBV Input, 0 dB analog gain
<0.05%
Common Mode Rejection Ratio
150Ω balanced source @ 1 kHz
>50 dB
Input Impedance
9.6 kΩ
Input Clipping Level
Line +27 dBV
Aux +15 dBV
Output Impedance
80 Ω
Output Clipping Level
Line +20 dBV
Aux +0 dBV
Mic -26 dBV
12.5 ms
5.8 ms
1.8 ms
2.2 ms