Removing Coffee Grounds And Water; Operation And Use - Fagor MQC-A10 US Guide D'utilisation Et D'entretien

6 REMOVING COFFEE GROUNDS AND WATER

6 REMOVING COFFEE GROUNDS AND WATER
After twenty coffees have been made, the message "COFFEE
GROUNDS" will appear on the display.
The container should be emptied. After this message appears, the
machine will allow 5 more coffees to be prepared and then it stops.
IMPORTANT:
The container must be emptied regularly to prevent the forma-
tion of mould and bacteria.
1. Open the drawer A.
2. Remove the grille B.
3. Extract and empty the coffee grounds container C and the water
container D.
4. Place the two containers and the grille back in their seats.
5. Close the drawer.
6. Press the key
beep of confi rmation.
Now the machine is ready for use again.
IMPORTANT: ALWAYS EMPTY THE GROUNDS CONTAINER

7 OPERATION AND USE

7 OPERATION AND USE
SWITCH-ON
Switch the machine on using the key
After a few seconds, the following message appears on the display
panel:
Welcome message
COFFEE
WATER
During the heating phase, the words COFFEE and WATER fl ash.
The machine is ready for use only when they have stopped
fl ashing.
The display also shows the type of coffee selected (short/medium/
long) as well as the choice of making one or two coffees at the
same time.
PROGRAMMING THE MACHINE
Various functions can be adjusted and programmed, as indicated
I C T- 0 1 I C T- 0 1
for about 3 seconds until you hear the
HELLO
1 SHORT
below:
To enter programming mode, with the machine off press the key
for 3 seconds until the display panel shows:
PROGRAMMING
Use the keys
med, which are, in order of appearance:
Pressing the key the display panel shows:
Use the keys
related to the hour fl ash.
E n g l i s h E n g l i s h
to select the functions to be program-
CLOCK
20:30
to set the hour. Initially the two digits
2 5 2 5