Evaluating Results - Beurer BC 81 Mode D'emploi

• appears if the measurement was not per-
formed properly. Refer to the chapter on error
messages/troubleshooting and then repeat the
measurement.
• Select a user memory number by pressing the
M1 or M2 button. If you do not select a user
memory, the measurement is stored in the
most recently used user memory. The active
user memory symbol M1 or M2 appears in the
LCD Display.
• Press the START/STOP button to switch off
the wrist blood pressure monitor. The mea-
surement is then stored in the selected user
memory.
• The device will shut off after about three min-
utes if no buttons are pressed. The last mea-
surement is still stored in the selected or most
recently used user memory.
• Wait at least 5 minutes before taking another
measurement.

6.5 Evaluating results

NOTE:
• A single measurement does not provide an
accurate indication of your true blood pressure.
You need to take and record several readings
over a period of time. Try to measure your
blood pressure at the same time each day for
consistency.
Irregular heartbeat
WARNING:
• The 'irregular heartbeat' function does not
replace a cardiac examination, but may help
to detect potential pulse irregularities at an
early stage. Always consult your physician to
determine what will be suitable for you.
• The 'irregular heartbeat' function is not
designed for diagnosing or treating an
arrhythmic disorder. Arrhythmia can only be
ascertained by a licensed physician.
19