Brandt BFA673YNX Manuel D'instruction page 57

The motor
continuously
A layer of frost occurs in
the compartment
Temperature inside is
too warm
Temperature inside is
too cold
Doors can't be closed
easily
Water drips on the floor
The light is not working
lt is normal to frequently hear the sound of the motor,
it will need to run more when in following
circumstances:
runs •Temperature setting is set colder than necessary
•Large quantity of warm food has recently been
stored within the appliance.
•The temperature outside the appliance is too high.
•Doors are kept open too long or too often.
•After you installed the appliance or it has been
switched off for a long time.
Check that the air outlets are not blocked by food and
ensure food is placed within the appliance to allow
sufficient ventilation. Ensure that is fully dosed. To
remove the frost, please refer to cleaning and care
chapter.
You may have left the doors open too long or too
frequently; or the doors are kept open by some
obstacle; or the appliance is located with insufficient
clearance at the sides, back and top
Increase the temperature by following the "Display
controls" chapter.
Check whether the top of the refrigerator is tilted back
by 10-15mm to allow the doors to self close, or if
something inside is preventing the doors from closing.
The water pan (located at the rear bottom of the
cabinet) may not be properly leveled, or the draining
spout (located underneath the top of the compressor
depot) may not be properly positioned to direct water
into this pan, or the water spout is blocked. You may
need to pull the refrigerator away from the wall to
check the pan and spout.
•The LED light may be damaged. Refer to replace LED
lights in cleaning and care chapter.
•The control system has disabled the lights due to the
door being kept open for too long. Close and reopen
the door to reactivate the lights.
17