Samsung SWA-8500S Manuel D'utilisation page 9

4. Configure "ID SET" using the Soundbar's remote control
Press the VOL button on your remote control for 5~6 seconds until the "ID SET" message appears
on your Soundbar's display.
• Steps for "ID SET" may vary by the Soundbar model. Please read manual for your Soundbar.
If the manual does not provide "ID SET" instructions, follow steps described in the image below.
5 Sec
• The image of the Soundbar may differ from your Soundbar, depending on the model.
5. Turn on the Soundbar
Turn on the Soundbar using the Soundbar's remote control or by pressing the
the main Soundbar unit.
• Some Soundbar models will be automatically powered on after completing "4. ID SET" step.
• The image of the Soundbar may differ from your Soundbar, depending on the model.
6. Check if the LINK LED is solid blue (connection complete)
STANDBY
LINK
STANDBY
LINK
Blue is On
ID SET
ON
The LINK LED indicator stops blinking
and glows a solid blue when a
connection is established between the
Soundbar and the Wireless Receiver
Module.
ENG - 9
(Power) button on