Publicité
Drill pilot holes as illustrated.
3
CAUTION:
holding power of the lag bolt. To avoid potential
injuries or property damage: pilot holes MUST
be drilled to a depth of 89 mm (3½ in.), using a
5.5 mm (7/32 in.) diameter drill bit.
5.5 mm
(7/32 in.)
Improper use could reduce the
89 mm
(3½ in.)
Start upper lag bolts [14], hang frame assembly
4
on bolts [14], then slip "U" washers [11] onto
the upper bolts [14]. Lower bolts [14] use round
washers [12].
Tighten lag bolts [14] only until the washers [11]
and [12] are pulled fi rmly against the brace [03].
CAUTION:
holding power of the lag bolt. To avoid potential
injuries or property damage DO NOT over-
tighten the lag bolts [14].
13mm
(1/2 in.
)
Improper use could reduce the
[11]
[14]
[03]
[12]
[14]
[03]
13
Publicité
