Mi-T-M Corporation GEN-2000-iMM0/0DM0 Guide D'utilisation page 16

CONTROLS
DC TERMINALS: (Fig. 3)
DC electric power for battery charging is available.
- Red is positive (+) terminal.
- Black is negative (-) terminal.
DC CIRCUIT BREAKER: (Fig. 3)
DC circuit breaker shuts off electric current when the current
exceeds its limit or a malfunction occurs in the connected
appliance.
Check for excessive current consumption or defects in the
appliance. After making sure everything is in order, push
the button to the "ON" position.
CAUTION: IF CIRCUIT BREAKER CONTINUES
TO TRIP, CHECK APPLIANCE FOR DEFECT.
IF GENERATOR IS MALFUNCTIONING,
S E E Y O U R A U T H O R I Z E D M I - T- M
SERVICE CENTER.
NEVER INTERFERE WITH THE OPERATION
OF THE CIRCUIT BREAKER KNOB OR
K E E P P U S H I N G I T I N T H E " O N "
POSITION.
RECOIL STARTER: (Fig. 4)
Pull this handle to start the generator.
GROUND TERMINAL: (Fig. 3)
Terminal for grounding the generator.
FUEL TANK CAP: (Fig. 5)
The fuel tank cap is located under the cover. To open
the cover, lift up and towards the muffler end as shown
in the illustration. Remove the fuel tank cap by turning
counterclockwise.
SIDE COVER: (Fig. 6)
To access the following items for servicing, take the
applicable side cover out by removing the screw with a
screwdriver.
LH-Side Cover - Air cleaner, etc.
RH-Side Cover - Oil level gauge, Ignition Coil etc.
16
Controls
screws
cover
(Fig. 3)
V
AC 120
(Fig. 4)
(Fig. 5)
(Fig. 6)
Operator's Manual