Bosch GKS 165 Professional Notice Originale page 12

OBJ_BUCH-692-001.book Page 12 Thursday, July 10, 2008 2:45 PM
12 | English
Operation
Operating Modes
Before any work on the power tool itself,
pull the mains plug.
Adjusting the Cutting Depth (see figure D)
Adjust the cutting depth to the thickness of
the workpiece. Less than a full tooth of the
blade teeth should be visible below the work-
piece.
Loosen wing bolt 25. For less cutting depth, pull
the saw away from the base plate 11; for more
cutting depth, push the saw toward the base
plate 11. Tighten wing bolt 25 again.
Adjusting the Cutting Angle
It is best to place the power tool on the face side
of the blade guard 14.
Loosen the wing bolts 6 and 26. Tilt the saw
sidewards. Adjust the desired measure on the
scale 4. Tighten the wing bolts 6 and 26 again.
Cutting Marks
45 0
The 0° cutting mark (8) indicates the position of
the saw blade for right-angled cuts. The 45° cut-
ting mark (7) indicates the position of the saw
blade for 45° cuts.
For precise cuts, position the circular saw
against the workpiece as shown in the figure. It
is best to carry out a trial cut.
Starting Operation
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the type plate of the
power tool.
1 609 929 N82 | (10.7.08)
Switching On and Off
(3 601 E23 X../3 601 E23 0B./3 601 E22 X..)
To start the power tool, first push the lock-off
button for the On/Off switch 2 and then press
the On/Off switch 1 and keep it pressed.
To switch off the power tool, release the On/Off
switch 1.
Note: For safety reasons, the On/Off switch 1
cannot be locked on but must remain pressed
during operation.
Switching On and Off
(3 601 E23 0C./3 601 E23 0K./
3 601 E23 0L./3 601 E22 0..)
To start the power tool, press the On/Off switch
1 and keep it pressed.
To lock the pressed On/Off switch 1, press the
lock-on button 2.
To switch off the power tool, release the On/Off
switch 1 or when it is locked with the lock-on but-
ton 2, briefly press the On/Off switch 1 and then
release it.
Working Instructions
Protect saw blades against impact and shock.
Guide the power tool evenly and with moderate
feed in the cutting direction. A high feed rate sig-
45 0
nificantly reduces the service life of the cutting
tools and can damage the machine.
Sawing performance and cutting quality depend
essentially on the condition and the tooth form of
the saw blade. Therefore, use only sharp saw
blades that are suited for the material to be
worked.
Sawing Wood
The correct selection of the saw blade depends
on the type and quality of the wood and whether
lengthway or crossway cuts are required.
When cutting spruce lengthways, long spiral
chips are formed.
Beech and oak dusts are especially detrimental
to health. Therefore, work only with dust extrac-
tion.
Bosch Power Tools