Troubleshooting - IKEA Lagan Utilisation

ENGLISH
5
Remove filter (A).
Wash the filter with
water.
7
An incorrect position of the filters can
cause bad washing results and dam-
age to the appliance.

Troubleshooting

The appliance does not start or it stops dur-
ing operation.
Before you contact the Service, refer to the
information that follows for a solution to the
problem.
6
D
Put filter (A) to its
initial position.
Make sure that it
assembles correctly
under the two
guides (D).
8
Assemble filters (B)
and (C). Put them
into position in filter
(A). Turn the handle
clockwise until it
locks.
Cleaning the filter of inlet hose
1
Close the water tap.
3
Clean the filter of
inlet hose.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged,
remove remaining parts of soil with a thin
pointed object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.
With some problems, different indicators
flash continuously or intermittently at the
same time to show an alarm code.
13
2
A
B
Disconnect the
hose. Press the lever
B and turn the fas-
tener A clockwise.
4